Removing
(
Refitting
)
|
|
Removing
(
Refitting
)
|
|
- Disconnect the negative battery terminal.
Op. 2127E12 ELECTROHYDRAULIC SELECTION GEARBOX ECU GUARD - R.R. |
|
 |
1. Disconnect the electrical connections for the electronic control unit.
|
 |
1. Undo the screws (1a) and open the retaining tabs (1b) for the control unit support. |
 |
1. Release and remove the gearbox electrohydraulic selection control system electronic control unit. |
 |
Refitting
(
Removing
)
1. Place the gearbox electrohydraulic selection control system electronic control unit in position. 2. Close the retaining tabs (2a) and secure them using the screws (2b). |
 |
1. Connect the electrical connections for the electronic control unit.
|
|
|
Op. 2127E12 ELECTROHYDRAULIC SELECTION GEARBOX ECU GUARD - R.R. |
|
- Connect the negative battery terminal.
|
|
- Only in the case of replacement, connect the Examiner and run the self-learning procedure of the values for the gear engagement/selection positions and check that the engagement position travel is correct. |